|
|
|
|
|
|
|
|
|
|
|
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||
MATERIAL SAFETY DATA SHEET
HILTI, INC.:
PRODUCT NAME: CC400EP Clear Epoxy Sealer, Part A DESCRIPTION: Amine hardener for CC400 EP water based epoxy INGREDIENTS AND EXPOSURE LIMITS
PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. These are 8 hour time-weighted averages unless otherwise indicated by "C" (Ceiling) or "STEL" (Short Term Exposure Limit). A "skin" notation indicates exposure should be controlled for the cutaneous routes including the mucous membranes, eyes, and skin. Airborne exposures as well as direct contact must be considered. NE = None Established. NA = Not Applicable. PHYSICAL DATA
FIRE AND EXPLOSION HAZARD DATAFLASH POINT: >200°F, PMCC FLAMMABLE LIMITS: Not Applicable EXTINGUISHING MEDIA: Carbon Dioxide, Dry Chemical, Foam, Water Fog. SPECIAL FIRE FIGHTING PROCEDURES: A self-contained breathing apparatus should be worn when fighting fires involving chemicals. UNUSUAL FIRE AND EXPLOSION HAZARDS: Thermal decomposition and combustion products can be formed. REACTIVITY DATAINCOMPATIBILITY: Strong oxidizers, peroxides, acids. STABILITY: Stable. HAZARDOUS DECOMPOSITION PRODUCTS: Thermal decomposition can yield CO, CO2, and NOx. HAZARDOUS POLYMERIZATION: Will not occur. CONDITIONS TO AVOID: Excessive heat for prolonged periods of time. Epoxy resins in uncontrolled amounts. HEALTH HAZARD DATAKNOWN HAZARDS: Eye, skin and respiratory irritation. CARCINOGENICITY: No ingredients are classified by IARC, NTP, or OSHA as known or potential carcinogens. PRIMARY ROUTES OF EXPOSURE: Dermal. SIGNS AND SYMPTOMS OF EXPOSURE: Contact: Eye and skin irritation. Corneal injury not expected. Inhalation: High vapor concentrations can cause respiratory difficulty, nausea, dizziness. MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Eye, skin, and respiratory conditions. EMERGENCY AND FIRST AID PROCEDURESEYES: Immediately flush with plenty of water. Call a physician. SKIN: Wash with soap and water. Contaminated clothing should be laundered before reuse. INHALATION: Move victim to fresh air. Call a physician if symptoms persist. INGESTION: If conscious, give plenty of water to drink. Seek medical attention. Do not induce vomiting unless directed to by a physician. Never give anything by mouth to an unconscious person. OTHER: Referral to a physician is recommended if there is any question about the seriousness of the injury/exposure. CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENTVENTILATION: General, i.e. natural or mechanically induced fresh air movements. EYE PROTECTION: Splash-proof chemical goggles recommended. Safety glasses with side-shields at a minimum. SKIN PROTECTION: Gloves recommended. Cotton or impermeable (neoprene or rubber). RESPIRATORY PROTECTION: None normally required with adequate ventilation as noted above. Use a NIOSH-approved organic vapor cartridge respirator when working in areas with little or no air movement. Never enter a confined space unless wearing an appropriate air-supplied respirator. PRECAUTIONS FOR SAFE HANDLING AND USEHANDLING AND STORING PRECAUTIONS: Avoid contact with eyes, skin, or clothing. Keep from freezing. Wash thoroughly after handling. Store in a cool dry place. Store below 100°F. Keep container closed when not in use. SPILL PROCEDURES: Remove spillage with absorbent material and dispose in accordance with federal, state, and local regulations. REGULATORY INFORMATIONOSHA HAZARD COMMUNICATION: Prepared in accordance with the federal OSHA HazCom Standard. HMIS CODES: Health 1, Flammability 0, Reactivity 1, PPE B DOT SHIPPING NAME: Not regulated TSCA INVENTORY STATUS: Chemical components listed on TSCA inventory. SARA TITLE III, SECTION 313: This product does not contain any toxic chemicals which must be reported as defined in Section 313 of the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372. WASTE DISPOSAL METHODS: Consult with regulatory agencies or corporate personnel for disposal methods that comply with local, state, and federal health and environmental regulations.
HEALTH / SAFETY CONTACTS:
The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or warranty of any kind expressed or implied is made with respect to the information provided.
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||
MATERIAL SAFETY DATA SHEET
HILTI, INC.:
PRODUCT NAME: CC 400 EP Pigmented Epoxy Sealer, Part A (Hardener) DESCRIPTION: Polyamide hardener for water based epoxy INGREDIENTS AND EXPOSURE LIMITS
PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. These are 8 hour time-weighted averages unless otherwise indicated by "C" (Ceiling) or "STEL" (Short Term Exposure Limit). A "skin" notation indicates exposure should be controlled for the cutaneous routes including the mucous membranes, eyes, and skin. Airborne exposures as well as direct contact must be considered. NE = None Established. NA = Not Applicable. PHYSICAL DATA
FIRE AND EXPLOSION HAZARD DATAFLASH POINT: >200°F, PMCC FLAMMABLE LIMITS: Not Applicable EXTINGUISHING MEDIA: Carbon Dioxide, Dry Chemical, Foam, Water Fog. SPECIAL FIRE FIGHTING PROCEDURES: A self-contained breathing apparatus should be worn when fighting fires involving chemicals. UNUSUAL FIRE AND EXPLOSION HAZARDS: Thermal decomposition and combustion products can be formed. REACTIVITY DATAINCOMPATIBILITY: Strong oxidizers, peroxides, acids. STABILITY: Stable. HAZARDOUS DECOMPOSITION PRODUCTS: Thermal decomposition can yield CO, CO2, aldehydes, and acids. HAZARDOUS POLYMERIZATION: Will not occur. CONDITIONS TO AVOID: Excessive heat for prolonged periods of time. Epoxy resins in uncontrolled amounts. HEALTH HAZARD DATAKNOWN HAZARDS: Eye, skin and respiratory irritation. CARCINOGENICITY: No ingredients are classified by IARC, NTP, or OSHA as known or potential carcinogens. PRIMARY ROUTES OF EXPOSURE: Dermal. SIGNS AND SYMPTOMS OF EXPOSURE: Eye and skin irritation. Respiratory difficulty, nausea, dizziness. MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Eye, skin, and respiratory conditions. EMERGENCY AND FIRST AID PROCEDURESEYES: Immediately flush with plenty of water. Call a physician. SKIN: Wash with soap and water. Contaminated clothing should be laundered before reuse. INHALATION: Move victim to fresh air. Call a physician if symptoms persist. INGESTION: If conscious, give plenty of water to drink. Seek medical attention. Do not induce vomiting unless directed to by a physician. Never give anything by mouth to an unconscious person. OTHER: Referral to a physician is recommended if there is any question about the seriousness of the injury/exposure. CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENTVENTILATION: General, i.e. natural or mechanically induced fresh air movements. EYE PROTECTION: Splash-proof chemical goggles recommended. Safety glasses with side-shields at a minimum. SKIN PROTECTION: Gloves recommended. Cotton or impermeable (neoprene or rubber). RESPIRATORY PROTECTION: None normally required with adequate ventilation as noted above. Use a NIOSH-approved organic vapor cartridge respirator when working in areas with little or no air movement. Never enter a confined space unless wearing an appropriate air-supplied respirator. PRECAUTIONS FOR SAFE HANDLING AND USEHANDLING AND STORING PRECAUTIONS: Avoid contact with eyes, skin, or clothing. Wash thoroughly after handling. Store in a cool dry place. Store below 100°F. Keep container closed when not in use. Keep from freezing. SPILL PROCEDURES: Remove spillage with absorbent material and dispose in accordance with federal, state, and local regulations. REGULATORY INFORMATIONHAZARD COMMUNICATION: This MSDS has been prepared in accordance with the federal OSHA Hazard Communication Standard. HMIS CODES: Health 1, Flammability 0, Reactivity 1, PPE B DOT SHIPPING INFO: Not regulated TSCA INVENTORY STATUS: Chemical components listed on TSCA inventory. SARA TITLE III, SECTION 313: This product contains <0.5% glycol ether,2-butoxy ethanol (CAS 111-76-2) which is subject to reporting under Section 313 of the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372. WASTE DISPOSAL METHODS: Consult with regulatory agencies or corporate personnel for disposal methods that comply with local, state, and federal health and environmental regulations.
HEALTH / SAFETY CONTACTS:
The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or warranty of any kind expressed or implied is made with respect to the information provided. | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
|
|||||||||||||||||||||||||
MATERIAL SAFETY DATA SHEET
HILTI, INC.:
PRODUCT NAME: CC400EP Epoxy Sealer, Part B DESCRIPTION: Epoxy resin for CC400EP water based epoxy INGREDIENTS AND EXPOSURE LIMITS
PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. These are 8 hour time-weighted averages unless otherwise indicated by "C" (Ceiling) or "STEL" (Short Term Exposure Limit). NE = None Established. PHYSICAL DATA
FIRE AND EXPLOSION HAZARD DATAFLASH POINT: > 200 F, Setaflash FLAMMABLE LIMITS: Not Applicable EXTINGUISHING MEDIA: Not Applicable SPECIAL FIRE FIGHTING PROCEDURES: A self-contained breathing apparatus should be worn when fighting fires involving chemicals. UNUSUAL FIRE AND EXPLOSION HAZARDS: Thermal decomposition and combustion products can be formed. See below. REACTIVITY DATAINCOMPATIBILITY: Strong oxidizers, peroxides, acids. STABILITY: Stable. HAZARDOUS DECOMPOSITION PRODUCTS: Thermal decomposition can yield CO, CO2, aldehydes and acids. HAZARDOUS POLYMERIZATION: Will not occur. CONDITIONS TO AVOID: Excessive heat for prolonged periods of time. Reactions with some curing agents can generate large amounts of heat. HEALTH HAZARD DATAKNOWN HAZARDS: Eye and skin irritation. Sensitization. CARCINOGENICITY: No ingredients are classified by IARC, NTP, or OSHA as known or potential carcinogens. PRIMARY ROUTES OF EXPOSURE: Dermal. Inhalation. SIGNS AND SYMPTOMS OF EXPOSURE: Eyes - Irritation. Corneal injury is not likely. Skin - Can cause allergic skin reactions (e.g. rash, redness, itching) in susceptible individuals. Inhalation - No effects expected. Heated vapors can cause irritation. MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Eye, skin, and respiratory conditions. EMERGENCY AND FIRST AID PROCEDURESEYES: Immediately flush with plenty of water. Call a physician. SKIN: Wash with soap and water. Launder contaminated clothing before reuse. INHALATION: If ill effects occur, move victim to fresh air. Call a physician if symptoms persist. INGESTION: If conscious, give plenty of water to drink. Seek medical attention. Do not induce vomiting unless directed to by a physician. Never give anything by mouth to an unconscious person. OTHER: Referral to a physician is recommended if there is any question about the seriousness of the injury/exposure. CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENTVENTILATION: General, i.e. natural or mechanically induced fresh air movements. EYE PROTECTION: Splash-proof chemical goggles recommended while mixing. Safety glasses with side shields at a minimum. SKIN PROTECTION: Gloves recommended. Cotton or impervious (neoprene or rubber). RESPIRATORY PROTECTION: None normally required with adequate ventilation as noted above. Use a NIOSH-approved organic vapor cartridge respirator when working in areas with little or no air movement. Never enter a confined space unless wearing an appropriate air-supplied respirator. PRECAUTIONS FOR SAFE HANDLING AND USEHANDLING AND STORING PRECAUTIONS: Avoid contact with eyes, skin, or clothing. Wash thoroughly after handling. Store in a cool dry place. Keep from freezing. Store below 100°F. Keep container closed when not in use. SPILL PROCEDURES: Remove spillage with absorbent material and dispose in accordance with federal, state, and local regulations. REGULATORY INFORMATIONOSHA HAZARD COMMUNICATION: Prepared in accordance with the federal OSHA HazCom Standard. HMIS CODES: Health 1, Flammability 0, Reactivity 1, PPE B DOT SHIPPING NAME: Non-regulated. TSCA INVENTORY STATUS: Chemical components listed on TSCA inventory. SARA TITLE III, SECTION 313: This product does not contain any toxic chemicals which are subject to reporting under Section 313 of SARA Title III (40 CFR Part 372). WASTE DISPOSAL METHODS: Consult with regulatory agencies or corporate personnel for disposal methods that comply with local, state, and federal health and environmental regulations.
HEALTH / SAFETY CONTACTS: The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or warranty of any kind expressed or implied is made with respect to the information provided. |
||||||||||||||||||||||||||
 |
||
| [MAIN MENU] | [TABLE OF CONTENTS] | [SELECTOR GUIDE] |
| [FIRESTOP PROGRAM] | [HAP PROGRAM] | [DECKING PROGRAM] |
| [HILTI WEB SITE] | [SEARCH] | [SUBMITTAL PACKAGE] |
